The working pressure of the automatic creasing machine is high, and the load of the moving parts is large, so its lubrication is very important, and the user should pay attention to it.

The friction surface and moving curved surface of the guide rail of the automatic creasing machine bear the load of the machine. If there is insufficient lubrication, its friction coefficient will increase greatly, causing damage to the moving sliding surface and becoming more and more serious.

Therefore, when using, be sure to inject lubricating oil on time to ensure the normal operation of the machine. When injecting oil into the guide rail, spray the oil gun directly on the plane of the guide rail and the mandrel of the curved ring, so as to ensure that the front part is fully lubricated. During this process, it is also necessary to monitor its sliding surface in real time. Check whether there are scratches, fluffing, etc., and if so, take corresponding measures.

The structure of the creasing machine is not complicated, so it is relatively convenient to use, but if it is not maintained correctly, it will still cause some failures. Before using the creasing machine, the user must read the manual carefully, and then use, adjust, and maintain it according to its requirements, so as to ensure that the machine can operate normally and the quality of the products produced is also guaranteed. Always check the various parts of the machine to see if there are any abnormalities and whether the parts are in good condition. If any damage or abnormality is found, the parts should be replaced or repaired in time.

When the machine is working, it is necessary to clean up the debris in time to prevent some debris from entering the guide rail surface and causing failure. In addition, it is necessary to pay attention to the pressure and cutting can not exceed the machine's bearing capacity, and maintain the balance and symmetry of the side and the plate distance. Appropriately add some lubricating oil each time before starting the machine. After starting the machine, check the safety device to ensure that the work is carried out safely. The electrical system of the machine must have good insulation to prevent the machine from getting damp.

If you want to know more product information, you can click here: creasing machine supplier.