Coil nail factory products in many areas we can to it, but many people don't know coil nail machine, today we take a look at what is the volume nail machine. According to introducing, the so-called volume nail machine is composed of a set of equidistant same shape arrangement of several single nail and fittings, fittings can be plated copper wire, pure copper wire, etc., fitting Iron Nail Making Machine in with the center line of the screw rod into fixed Angle oblique upward, connected to each nail, will string together all the nail, and then rolled into a roll, general fixed Angle of 0-90 degrees; And volume nail machine has a very wide range of applications, can be applied to mechanical nailing, also can be installed on the coil nail gun for nailing, its advantage to reduce manual labor, increase productivity.
Utility model volume nail machine, widely used, especially suitable for construction, decoration, furniture, wood, packaging, cars, etcCoil nail machine manufacturer's products during processing, if improper operation, often can appear some common problems, affects the quality of the products, then we have to get to know the related content.
According to understand, sometimes we will find that there is no head of nail screw machine products, this is a common fault, the causes of this phenomenon is mainly caused by wire clamp fixture not peg, this case need wire nail making machine to replace fixture, set aside, of course, it is possible that the head of nail wire nail is too short, adjust the nail wire length can be reserved at this moment.
And head of nail is not round, the failure problem is usually who usually because of the fixture, this time we'll be the first to observe whether the countersunk hole on the fixture is round, if you are not round need to drill; You also need to observe whether die fixture is rugged, if highly uneven can also be adjusted.
Volume and manufacturers to remind the broad masses of users, nail nail machine has certain scope, not volume nail machine applies to all industries, then we began to learn about related knowledge.
It is understood that the current volume nail machine is widely used in construction, decoration, decoration, decoration, no nail head nails, after laying no nail marks, features suitable for decoration industry. In the decoration industry are used in the ceiling, sheet, etc., can also be used for furniture production and all kinds of wood products; Secondly applies to wooden cases for outer plate fixed, also suitable for soft and hard wood, bamboo, ordinary plastic, wall casting, furniture, packaging wooden box, etc.
It is precisely because people and countries the huge demand for coil nail machine industry, make the coil nail machine manufacturers, coil nail machine industry's rapid development, as the replacement of the common round nails, coil nails machine the use effect of favored by users. Oil can separate coil nail machine from the air, to prevent the occurrence of corrupt phenomenon, coil nail machine to extend its service life, so how to give volume nail machine oil? Today volume nail machine manufacturers to our knowledge.
Coil nail machine oil has certain steps and skills, we must first is to nail manufacturing machine add ink, marked the beginning of coil nail machine oil at this time. Can be used to open the oil box, while others use a closed, the oil viscosity at this time must be low enough to make the ink can be evenly spread out on the surface of the coil nail machine, and able to enter the cave in the thread; Then let the etching ink into the concave area, it is important to note due to the evaporation of solvent is very fast, this will lead to image sag area on the surface of the oil than the oil below some glue. It suck, then the excess oil from oil sorbent surface, after fully dry again, can prevent the air between oil and coil nail machine, the air will cause uneven oil residue, the roll up, even if we can see the volume of screw machine products.